Strange India All Strange Things About India and world


  • Blender
  • Rolling Pin
  • Flat workspace
  • Kitchen sink with stopper, or large plastic tub
  • Kitchen Towels, or rags
  • Paper Blotters
  • Deckle (make your own, or buy one at a craft store)
  • nylon screen
  • sponge
  • leaves, moss, glitter, or other decorations
  • Paper – you can use old envelopes, papers, newspapers, stamps (but avoid glossy paper, like magazines)
  • Microwave or hair dryer, if desired

Step 1

Assemble your deckle by fitting the larger frame over the screened side of the smaller frame.

Step 2

Fill your sink or tub with warm water (so it feels nice to touch–not too hot, not too cold). The water should be about three inches deep.

Step 3

Now, it is time to make your paper pulp. Tear your paper into squares (about 1″). Combine water with the paper in your blender. It should be about 2:1, two parts water to 1 part paper. Blend until the pulp is soft. You might see some chunks, but not any big ones.

Step 4

You are ready to pour your pulp. Place your deckle and screen in the sink (or tub), so the water is about 1″ below the top of the deckle. Hold the deckle down under the water with one hand. With your free hand, pour the pulp into the deckle. Swish the deckle around.

Step 5

Lift the deckle straight up, draining the visible water. You want to keep the pulp even, so avoid tilting the deckle as you lift it. Once the visible water has drained, tilt the deckle. Wait for the water to stop draining.

Step 6

Place the deckle on a flat surface. Remove the top half of the deckle. There will be a layer of wet fiber (pulp) on the screen.

Step 7

Now, you need to sponge the pulp. Place your loose screen over the pulp. Use a moist sponge to evenly press over the pulp. Squeeze the sponge out into the sink, and repeat. You want to draw as much moisture out of the pulp as you can. Fold a kitchen towel, or rag, in half, then turn the pulp (with screen and deckle) over onto the towel. Use the sponge on the deckle screen to remove excess water. Squeeze out sponge and repeat.

Remove the deckle, leaving the pulp pressed against the loose screen. You can peel the pulp off of the deckle if it sticks.

Step 8

It is time to couch (pronounced koo-ch) the paper pulp. Flip the screen and pulp onto a piece of blotter paper. The pulp should be sandwiched between the screen and the blotter. Use a rolling pin to roll over the pulp sandwich. The pulp will transfer from the screen to the blotter. This method is called couching (kooching). Couch the paper again, onto a dry blotter. If your paper pulp is still really wet, couch again.

Step 9

Carefully lift one corner of the pulp sheet, slowly peeling it off of the blotter. It is time to let the paper dry. You can let it air dry (which takes 1-3 days depending on humidity), heat it in the microwave for about 1-2 minutes, or use a blow dryer on the paper.

Don’t be surprised if your paper curls. To flatten it, stick it under some heavy books overnight.

You have just made one piece of paper!

The Step-by-Step Photos

The Step-by-Step Photos on the right show how I went through the 9 steps to make paper. I wanted to make red paper, so I found some red scrap paper. I combined it with some white paper that had drawings on it. For texture, I added some dried moss. I also tossed in some cinnamon to give the paper a nice scent. I blended all of these together with some water.

Ready to Make More Paper?

The blotters need to be dry before you make more paper. Either have enough dry blotters on hand, or dry them in the microwave first. Instead of using blotters, you can also use felt pieces or rags.

If your screens start to stretch, simply use a blow dryer on them. This will help tighten them back up.

Embellish Your Paper

You can create different textures and designs by adding anything to the pulp that you can put into your blender – think spices (make it smell good too), essential oils, petals, potpourri, colored paper, food coloring, glitter, leaves, tea, and moss.

You can also add the embellishments to the pulp after you complete Step 4 from above. Simply place or sprinkle the items on the pulp, gently embedding them into the pulp. When you move on to Step 5, pulling the deckle out, the items will be stuck to the surface of the paper.

You can embed a picture (paper copy, not glossy) into your paper with this same process.

The Papermaking Videos

On the right, you will find three videos showing how to make paper. These videos are helpful to watch because they give you a general idea of the papermaking process.

Paper Making with Lonnie and Jacqueline: The process used to make paper in this video is most similar to the method I have described here. This video will show you how easy it is to make paper, plus it shows a few small differences in style between how paper is made in the video and the method provided here.

Making Paper with 4th Graders: This video shows you how easy it is to get children involved in papermaking projects. As well, it offers more ideas for paper decorating embellishments. The method shown here differs from mine, but allows you a look at another way of making paper.

Quick Papermaking Demo:This is a quick, simple demo showing how easy it is to make paper once all of your supplies are set up.

Leave a Reply

Your email address will not be published. Required fields are marked *